The cutting setting of welding head of the super powerful Weiye

I. Copper nozzle

Use a cutting copper nozzle (We recommend that copper nozzle 1.5 or more is enough.)

II. craft

Unlike welding, cutting spots has no width.

Therefore, the scan width must be set to 0, that is, the red light is a point.

Sweep speed: Ignore this parameter and feel free to do so

Scan width: 0

Peak power: The reference data recommends to be full power cutting, which is subject to actual conditions.

Duty Cycle: reference data is 100.

Pulse frequency: reference data is 1000.

After setting the parameters, if you import and go back, and you can see this process on the left side of the home page.

As to the focus, it is recommended to use negative focus (because it directly affects the cutting effect)

III. The center point of the red light

Generally use hardware to make adjustments, that is, to adjust the tail motor.

Adjustment method reference: Adjustment of red light

IV. Cutting workpieces

The requirements of focus: if you use retro-focus, the sluggish that it generates is less relatively.

The requirements of valve (using the reduced valves made of oxygen or argon pressure)

The requirements of gas:

If there is a requirement for the cutting surface, it is recommended to use nitrogen gas (be sure the weight of nitrogen is greater than 6 kg) which means to compare with the cutting surface, it will be whitish relatively.

If the thickness of the cut is required, please use oxygen or air to cut, and it will be blackened compares with the cutting surface.

Cutting thickness: 3 mm or less is the best.

Hand speed is maintained evenly when cutting.